Edge repair of Subsonic deck- part 2
Moderator: Marion Karr
-
Paul Howard
- Posts: 202
- Joined: Sat Dec 27, 2003 7:15 pm
- Location: Corvallis, Oregon. USA
Edge repair of Subsonic deck- part 2
Here's the initial damage from a skogging mishap, and fixing it with JB Weld and 1/16" RC Aircraft plywood and fiberglass. Hope you like it.
- Attachments
-
- Board Repair 008 (2).JPG (1.62 MiB) Viewed 6749 times
-
- Board Repair 009 (2).JPG (695.71 KiB) Viewed 6749 times
-
- Once this JB is cured rasp flat and sand it.
- Board Repair 010 (2).JPG (1.31 MiB) Viewed 6749 times
-
- Use a rough wood rasp to rasp the JB Weld down flush with the deck, then fit your plywood to the area you want to repair.
- Board Repair 013 (2).JPG (1.2 MiB) Viewed 6749 times
-
- Mix up more JB WELD Epoxy, place the plywood pieces where you want them, then clamp "Snug - NOT Tight"!!!
- Board Repair 016 (2).JPG (1.06 MiB) Viewed 6749 times
-
- Board Repair 017 (2).JPG (1.25 MiB) Viewed 6749 times
-
- Again, Use the Heat-gun to make the JB Weld cure harder and cure WAY faster.
- Board Repair 018 (2).JPG (1.35 MiB) Viewed 6749 times
-
- Board Repair 019 (2).JPG (1.2 MiB) Viewed 6749 times
-
- Board Repair 021 (4).JPG (359.15 KiB) Viewed 6749 times
-
- Cut and file to shape before fiberglassing.
- Board Repair 022 (2).JPG (886.21 KiB) Viewed 6749 times
I just dig slalom!