It's only a matter of time until snowboard manufacturer Burton comes along. Here's an early (homemade) prototype, shaped out of a Burton board.
They guy in the picture commented: "Cutting it out of a Burton snowboard was cheaper than getting a regular slalom deck. It also allowed me to select the thickness in the front vs the rear of the board as snowboards are thicker under the bindings then further back."
Burton board
Moderator: Marion Karr
-
- ISSA President 2011-2024
- Posts: 4652
- Joined: Thu Aug 22, 2002 2:00 am
- Location: Sweden, lives in France
- Contact:
-
- Posts: 8
- Joined: Thu Jun 26, 2003 2:00 am
- Location: Sweden