...shitty tapeswitch! Has anyone ever even built? It is not about the price but the shelf!
For tips and suggestions always happy!
cheers prikel
shitty tapeswitch
Moderator: Jani Soderhall
-
- prikelpit
- Posts: 49
- Joined: Wed Apr 16, 2008 6:24 am
- Location: Berlin west sure
-
- ISSA President 2011-2024
- Posts: 4656
- Joined: Thu Aug 22, 2002 2:00 am
- Location: Sweden, lives in France
- Contact:
-
- Pat C.
- Posts: 1400
- Joined: Mon Sep 16, 2002 2:00 am
- Location: Portland Oregon
I built my own, but they were less reliable than www.tapeswitch.com
-
- prikelpit
- Posts: 49
- Joined: Wed Apr 16, 2008 6:24 am
- Location: Berlin west sure
-
- 1961-2013 (RIP)
- Posts: 3279
- Joined: Tue Aug 27, 2002 2:00 am
Peter,
Two things.
One: tapeswitches must ALWAYS be stored flat. Some people roll them up but that's still an invitation to crimp the metal. If you laid one down and didn't tape then probably that allowed a wheel to crunch the switch instead of roll over it.
Two: building a tapeswitch type mechanism is really not feasible. It's been tried.
What I would suggest is take the plunge, buy new strips and invest in a storage case that can be used to keep the strips flat. What I did was went to a home store and bought a length of 12-cm (5 inch) plastic pipe and two end caps. I cut the pipe at about 4.5 feet in length. I slide all the switches in flat and have enough room to also put in the connecting wires. A 5-inch tube is also wide enough to hold the TrakMate timer. Everything all in one container and the switches won't get crimped. That plus my cable spool is my timer.
![Image](http://www.slalomskateboarder.com/Stuff/TimeTube-1.jpg)
![Image](http://www.slalomskateboarder.com/Stuff/TimeTube-2.jpg)
Two things.
One: tapeswitches must ALWAYS be stored flat. Some people roll them up but that's still an invitation to crimp the metal. If you laid one down and didn't tape then probably that allowed a wheel to crunch the switch instead of roll over it.
Two: building a tapeswitch type mechanism is really not feasible. It's been tried.
What I would suggest is take the plunge, buy new strips and invest in a storage case that can be used to keep the strips flat. What I did was went to a home store and bought a length of 12-cm (5 inch) plastic pipe and two end caps. I cut the pipe at about 4.5 feet in length. I slide all the switches in flat and have enough room to also put in the connecting wires. A 5-inch tube is also wide enough to hold the TrakMate timer. Everything all in one container and the switches won't get crimped. That plus my cable spool is my timer.
![Image](http://www.slalomskateboarder.com/Stuff/TimeTube-1.jpg)
![Image](http://www.slalomskateboarder.com/Stuff/TimeTube-2.jpg)
![Image](http://www.slalomskateboarder.com/Boards/Ick/ClippedIck-Logogrey.jpg)