Metal Angled Risers
Posted: Sun Mar 22, 2009 6:56 pm
We are making risers to match the Virage trucks. We are doing production 3 and 5 degree wedges with a thin end (thinner than the picture). The rear holes are designed to be elongated to allow for bolts going through an angled baseplate.
Whilst these are designed to match the Virage we didnt copy the actual baseplate shape at the sides, this is so they will match a variety of trucks, in fact the outer shape matches very closely those of a Tracker.
We can also make any sized riser to any depth, so if you have a stack of risers on your deck we can take those diemsions and angles and replicate it with one, stiff, aluminium riser. However, I do like to run with 1/8th" soft khiro riser under the deck just to add a touch of dampenning.
Whilst these are designed to match the Virage we didnt copy the actual baseplate shape at the sides, this is so they will match a variety of trucks, in fact the outer shape matches very closely those of a Tracker.
We can also make any sized riser to any depth, so if you have a stack of risers on your deck we can take those diemsions and angles and replicate it with one, stiff, aluminium riser. However, I do like to run with 1/8th" soft khiro riser under the deck just to add a touch of dampenning.