Sweden - wooden ramp in Täby
Posted: Wed Mar 12, 2003 8:04 pm
Here are a few pictures of an old ramp we had built in 1978. It was used for quite a few local races until the early 80's.
It's primary advantage was the heavy weight so that it would not lift when two racers pulled off at the same time.
It also had a convenient transition, although straight, and a slight rounding where the ramp hit the street. It is important to make this rounding of rather solid steel because any softer metal will easily bend after plenty of runs over the final bend. In the beginning it was all wood, as on the picture, but it was replaced after a some rainy days with steel.
Another great advantage of this ramp was that it could be taken apart and transported without a single screw or bolt being used. The carpenter figured it all out himself and it was great for transportation and for winter storage.
![Image](http://www.slalomskateboarder.com/images/Ramps/Sweden_StartRampConstruction1978_PB.jpg)
These pictures were taken on the very day of the installation of these ramps.
![Image](http://www.slalomskateboarder.com/images/Ramps/Sweden_RampStartLarsi_PB.jpg)
That's my brother Larsi going down the ramp the very first time. Probably on an Alva board with Tracker mid and red Kryptonics 65 mm.
It's primary advantage was the heavy weight so that it would not lift when two racers pulled off at the same time.
It also had a convenient transition, although straight, and a slight rounding where the ramp hit the street. It is important to make this rounding of rather solid steel because any softer metal will easily bend after plenty of runs over the final bend. In the beginning it was all wood, as on the picture, but it was replaced after a some rainy days with steel.
Another great advantage of this ramp was that it could be taken apart and transported without a single screw or bolt being used. The carpenter figured it all out himself and it was great for transportation and for winter storage.
![Image](http://www.slalomskateboarder.com/images/Ramps/Sweden_StartRampConstruction1978_PB.jpg)
These pictures were taken on the very day of the installation of these ramps.
![Image](http://www.slalomskateboarder.com/images/Ramps/Sweden_RampStartLarsi_PB.jpg)
That's my brother Larsi going down the ramp the very first time. Probably on an Alva board with Tracker mid and red Kryptonics 65 mm.