Edge repair of wood/fiberglass Subsonic Deck - Part 1

Slalom Skateboard Decks forum

Moderator: Marion Karr

Post Reply
Paul Howard
Posts: 202
Joined: Sat Dec 27, 2003 7:15 pm
Location: Corvallis, Oregon. USA

Edge repair of wood/fiberglass Subsonic Deck - Part 1

Post by Paul Howard » Sun Jun 14, 2020 1:46 am

This is a 3 part series of a LOT of pictures of step by step fixing a torn out piece of my deck from a skogging mishap recently. Hope you like this.
Attachments
Board Repair 001 (2).JPG
The torn out rear foot stopper and chuck of deck that came out with it.
Board Repair 001 (2).JPG (1.15 MiB) Viewed 5061 times
Board Repair 006 (2).JPG
Stuffing the wood pieces back in and....
Board Repair 006 (2).JPG (747.78 KiB) Viewed 5061 times
Board Repair 007 (2).JPG
holding them in with JB Weld Epoxy and tape walls.
Board Repair 007 (2).JPG (474.03 KiB) Viewed 5061 times
Board Repair 008 (2).JPG
Use a heat-gun to heat the JB Weld and it will cure WAY faster, WAY harder. Be careful not to over heat it or it will bubble.
Board Repair 008 (2).JPG (1.62 MiB) Viewed 5061 times
I just dig slalom!

Post Reply