Edge repair of wood/fiberglass Subsonic Deck - Part 1
Moderator: Marion Karr
-
Paul Howard
- Posts: 202
- Joined: Sat Dec 27, 2003 7:15 pm
- Location: Corvallis, Oregon. USA
Edge repair of wood/fiberglass Subsonic Deck - Part 1
This is a 3 part series of a LOT of pictures of step by step fixing a torn out piece of my deck from a skogging mishap recently. Hope you like this.
- Attachments
-
- The torn out rear foot stopper and chuck of deck that came out with it.
- Board Repair 001 (2).JPG (1.15 MiB) Viewed 10034 times
-
- Stuffing the wood pieces back in and....
- Board Repair 006 (2).JPG (747.78 KiB) Viewed 10034 times
-
- holding them in with JB Weld Epoxy and tape walls.
- Board Repair 007 (2).JPG (474.03 KiB) Viewed 10034 times
-
- Use a heat-gun to heat the JB Weld and it will cure WAY faster, WAY harder. Be careful not to over heat it or it will bubble.
- Board Repair 008 (2).JPG (1.62 MiB) Viewed 10034 times
I just dig slalom!